- Joined
- Mar 4, 2013
- Messages
- 3,029
Both SOLD!!
#1 - Boot Skinner design in 1/8" hollow ground CPM S90V, heat treated by Peters' to 61-62 HRC. Blade length is ~3 inches, OAL is 7.25 inches. The tang is tapered and wears some well figured, and sculpted, curly walnut with red G10 liners, attached with copper corby bolts and has a red G10 accent pin. Spine is rounded and has a short bit of 30 LPI serrations. Makes an excellent EDC!
The sheath is design for cross draw carry. I personally prefer this sheath; I wore a similar sheath for the 7-hour drive to Atlanta and barely noticed it was there.
#2 - Drop point in 1/8" S90V heat treated by Peters' to 61-62 RC. Features a 3" full hollow ground blade, satin finished, with a rounded spine and 30lpi thumb serration. The tang is tapered and wears beautifully figured curly walnut with red G10 liners, secured with copper corbies and lanyard tube.
Rides in a hand stitched leather sheath with matched red stitching.
#1 - Boot Skinner design in 1/8" hollow ground CPM S90V, heat treated by Peters' to 61-62 HRC. Blade length is ~3 inches, OAL is 7.25 inches. The tang is tapered and wears some well figured, and sculpted, curly walnut with red G10 liners, attached with copper corby bolts and has a red G10 accent pin. Spine is rounded and has a short bit of 30 LPI serrations. Makes an excellent EDC!
The sheath is design for cross draw carry. I personally prefer this sheath; I wore a similar sheath for the 7-hour drive to Atlanta and barely noticed it was there.
#2 - Drop point in 1/8" S90V heat treated by Peters' to 61-62 RC. Features a 3" full hollow ground blade, satin finished, with a rounded spine and 30lpi thumb serration. The tang is tapered and wears beautifully figured curly walnut with red G10 liners, secured with copper corbies and lanyard tube.
Rides in a hand stitched leather sheath with matched red stitching.
Last edited:
....Blades and Pants.....
