- Joined
- Aug 31, 2011
- Messages
- 3,119
Small Knife #1 (SOLD):
Thin behind the edge, though I do not have calipers to measure exactly how thin.
Blade Length: 2 5/8"
Thickness In Ricasso: ~.102"
OAL: 6 7/16"
Heat Treat: Paul Bos for 61 HRC
Handle: bubinga sanded and buffed, no varnish on it. Glued on with G-Flex.
Issues: a few rust spots that are visible in the pictures. That was because I left the blade covered in tape for too long. Sheath is less than perfect, as are all of my handmade sheaths.
Asking $42, which includes Priority shipping tyd anywhere in USA.
Small Knife #2:
Blade Length: 2 3/4"
Blade Thickness in Ricasso: ~.091"
Overall Length: 6 13/16"
Heat Treat: Paul Bos for 61 HRC
Handle: G10 liners and mystery wood - probably hickory - with tung oil finish. Glued with G-Flex.
Issues: 1.) a few rust spots from leaving it sit with the blade taped up. 2.) Grind problem you can see if you look at the top of the spine in the picture, you can see where I ground a little into the spine on the left.
Asking $50, which includes Priority shipping tyd anywhere in USA
Thank you for looking.
Andy
Thin behind the edge, though I do not have calipers to measure exactly how thin.
Blade Length: 2 5/8"
Thickness In Ricasso: ~.102"
OAL: 6 7/16"
Heat Treat: Paul Bos for 61 HRC
Handle: bubinga sanded and buffed, no varnish on it. Glued on with G-Flex.
Issues: a few rust spots that are visible in the pictures. That was because I left the blade covered in tape for too long. Sheath is less than perfect, as are all of my handmade sheaths.
Asking $42, which includes Priority shipping tyd anywhere in USA.
Small Knife #2:
Blade Length: 2 3/4"
Blade Thickness in Ricasso: ~.091"
Overall Length: 6 13/16"
Heat Treat: Paul Bos for 61 HRC
Handle: G10 liners and mystery wood - probably hickory - with tung oil finish. Glued with G-Flex.
Issues: 1.) a few rust spots from leaving it sit with the blade taped up. 2.) Grind problem you can see if you look at the top of the spine in the picture, you can see where I ground a little into the spine on the left.
Asking $50, which includes Priority shipping tyd anywhere in USA
Thank you for looking.
Andy
Last edited:
