Robert Erickson
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 2, 2014
- Messages
- 2,882
Hey guys,
Sometimes you just need something Sharp and Pointy and well I think I have just the right Thing. Not much else to say except this is 3V steel at RC62 and the handle is green canvas micarta. If you're looking for frills, look elsewhere, but if you'd like to cut some stuff (or poke it) look no further.
SPECS:
OAL: 9"
BLADE: 4" long, 1.4" wide. It has been hand sanded to 400 grit. The grind is compound full flat/convex. the edge is down to 0.010" before sharpening.
STEEL: 0.125" 3V tool steel heat treated to RC62 including LN cryo.
HANDLE: Green canvas micarta and stainless steel pins and lanyard tube.
SHEATH: TekLok ready Kydex sheath included.
Price: $SOLD Shipped CONUS
international buyers welcome, shipping extra.
Paypal, checks or money orders accepted.
Post "I'll take it" here in this thread and then PM or email me for arrangements.
Comments/Questions/Critiques welcome.
Thanks for looking!
Sometimes you just need something Sharp and Pointy and well I think I have just the right Thing. Not much else to say except this is 3V steel at RC62 and the handle is green canvas micarta. If you're looking for frills, look elsewhere, but if you'd like to cut some stuff (or poke it) look no further.
SPECS:
OAL: 9"
BLADE: 4" long, 1.4" wide. It has been hand sanded to 400 grit. The grind is compound full flat/convex. the edge is down to 0.010" before sharpening.
STEEL: 0.125" 3V tool steel heat treated to RC62 including LN cryo.
HANDLE: Green canvas micarta and stainless steel pins and lanyard tube.
SHEATH: TekLok ready Kydex sheath included.
Price: $SOLD Shipped CONUS
international buyers welcome, shipping extra.
Paypal, checks or money orders accepted.
Post "I'll take it" here in this thread and then PM or email me for arrangements.
Comments/Questions/Critiques welcome.
Thanks for looking!
Last edited:
