timos-
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 22, 2012
- Messages
- 2,164
.110 thick AEB-L stainless Heat treated by Peters to RC 60.
Bevels are ground on 36" radius platen.
Blade is about 4.375"
Handle is for smaller hand. only 4" long to utilize 3 finger or pinch grip
Handle material is OD green canvas micarta with thin white g10 liners.
Pin is 304 SS and lanyard tube is also 304 stainless.
West systems Marine epoxy was used.
I have done some light testing with this knife, It is great for a saltwater/wet environment. I designed this knife to cut semi frozen bait up and clean small fish. It is thick for a filet and has very little flex.
Notice the bolster area are not identical on both sides. This is made for a right handed pinch grip. Very comfortable. The Micarta is very grippy when wet.
I have hand sharpened this knife and honed it with 4000/8000 grit wet stone. It is shaving sharp.
Price is 100$SOLD
I will accept paypal, check, money order.
Bevels are ground on 36" radius platen.
Blade is about 4.375"
Handle is for smaller hand. only 4" long to utilize 3 finger or pinch grip
Handle material is OD green canvas micarta with thin white g10 liners.
Pin is 304 SS and lanyard tube is also 304 stainless.
West systems Marine epoxy was used.
I have done some light testing with this knife, It is great for a saltwater/wet environment. I designed this knife to cut semi frozen bait up and clean small fish. It is thick for a filet and has very little flex.
Notice the bolster area are not identical on both sides. This is made for a right handed pinch grip. Very comfortable. The Micarta is very grippy when wet.
I have hand sharpened this knife and honed it with 4000/8000 grit wet stone. It is shaving sharp.
Price is 100$SOLD
I will accept paypal, check, money order.
Last edited:
