G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,793
Also my preferred size knife for field dressing a whitetail deer
Forged from 52100 high carbon steel
Heat treated in digitally controlled equipement with three normalizing and two tempering cycles to Rc 58-60 with attention to a fine grain pattern throughout the blade
Flat grind
Professionally stabilized (K&G) curly maple handle with a piece of blacktail deer antler that I found in Alaska. It was partially buried in moss and picked up a green hue
Overall length: 7 3/4 inches
Blade: 3 1/4 inches
Leather scabbard with a belt loop for a right hand carry
sold delivered within the US. My email and PayPal address is gldrewknives@gmail.com
IMG_5669 by Gerald Drew, on Flickr
IMG_5669 by Gerald Drew, on Flickr
IMG_5672 by Gerald Drew, on Flickr
IMG_5676 by Gerald Drew, on Flickr
Forged from 52100 high carbon steel
Heat treated in digitally controlled equipement with three normalizing and two tempering cycles to Rc 58-60 with attention to a fine grain pattern throughout the blade
Flat grind
Professionally stabilized (K&G) curly maple handle with a piece of blacktail deer antler that I found in Alaska. It was partially buried in moss and picked up a green hue
Overall length: 7 3/4 inches
Blade: 3 1/4 inches
Leather scabbard with a belt loop for a right hand carry
sold delivered within the US. My email and PayPal address is gldrewknives@gmail.com
IMG_5669 by Gerald Drew, on FlickrIMG_5669 by Gerald Drew, on FlickrIMG_5672 by Gerald Drew, on FlickrIMG_5676 by Gerald Drew, on Flickr
Last edited:
