*sold

[Mikey13folsom]

$old shipped g&s
M390 bento box pm2 with Ti flytanium scales, Ti clip, and Ti backspacer. User, slightly off center but free dropper. Great detent and lockup. The backspacer came free because the dude messed up and made the holes for the standoffs too big (its made to slip over them). I have Teflon tape around one standoff to hold the spacer on tight, look at video for explanation, doesn't look bad. Does not come with original scales or box.
ZT550blk-WITHDRAWN
ZT550 Custom Ti scale/liner delete (shown installed on ZT550 but knife is not included) - sold
Paypal only, US shipping only.

Videos are here:
http://imgur.com/a/WFVcDZq

Pictures are here:
http://imgur.com/a/t5fcrKs

Thanks!

 

[golden_dragon]

PM sent.

 

[Applecider3]

So on the pm2 is it the scales that are screwed up or the spacer, if scales are drill holes or indents too big?

 

[Mikey13folsom]

So on the pm2 is it the scales that are screwed up or the spacer, if scales are drill holes or indents too big?

The spacer slips over the standoffs, so its basically supposed to be held in place by the scales and fit of the standoffs. However, the maker made the holes where the standoffs fit, a little too big so there was play there. I wrapped Teflon tape around a standoff to make it fit better without play. There's a slight gap as shown in the video, but not too bad.

 

[Applecider3]

Again so the defect is in the scales then? With holes in them too big right? Getting late nite and I’m groggy, so don’t take any attitude I have personally.

 

[Mikey13folsom]

Again so the defect is in the scales then? With holes in them too big right? Getting late nite and I’m groggy, so don’t take any attitude I have personally.

There's no problem with the scales, the issue is with the spacer. Nothing to do with the scales.

 

[FLBags]

PM on PM
Thanks

 

[Mikey13folsom]

PM on PM
Thanks

Replied