- Joined
- Feb 15, 2014
- Messages
- 632
let's blow this one out. There's a little Sharpie left on the blade that I could not remove with rubbing alcohol. I do not have any nail polish remover or acetone right now. I'm asking $405
sale today is my blue XM
This one has never been carried or had loctite applied to the pivot screw. I merely copied the factory angle of 20 degrees per side and took it up to 600 grit. It is ready for whatever edge you want to put on. The blade steel on this slicer grind is CPM20CV.
Please check out my website and give me some input on what patterns and materials you would like to see.http://www.agfcustomknives.com
If you could just send me a Facebook message with that information that would be perfect. My name is Stephen Sharkey and my avatar picture is 2 Hinderer knives.
This one also comes with a full set of stainless steel black coated Hardware. This Hardware has not been used.
I am asking $495 shipped Xpress Post
I will accept PayPal or EMT.
Thank you very much for looking
sale today is my blue XM
This one has never been carried or had loctite applied to the pivot screw. I merely copied the factory angle of 20 degrees per side and took it up to 600 grit. It is ready for whatever edge you want to put on. The blade steel on this slicer grind is CPM20CV.
Please check out my website and give me some input on what patterns and materials you would like to see.http://www.agfcustomknives.com
If you could just send me a Facebook message with that information that would be perfect. My name is Stephen Sharkey and my avatar picture is 2 Hinderer knives.
This one also comes with a full set of stainless steel black coated Hardware. This Hardware has not been used.
I am asking $495 shipped Xpress Post
I will accept PayPal or EMT.
Thank you very much for looking
Last edited:
