Sold

[Rwfeath92]

Mini WP
6” OAL
2” cutting edge
Comes with kydex sheath and ulticlip
Unsure of steel as it’s unmarked

Has been carried a few times and cut a few things, the mark on backside from may be from the kydex
But not sure. $275 OBRO

https://imgur.com/a/X0zC8lA

 

[JWBirch]

Unmarked has typically indicated S30V, but that info is dated. Strider primarily uses particle or powder steels that are tougher than ingot equivalents when properly heat and cryo treated. Performance differences between Strider steels are said to be indistinguishable by end users. In personal experience, I've used Strider's S30V more than any other, and it has become what I consider my benchmark for S30V. Just thinking, this would be a good alternative to a Kiridashi.

What's the thickness?

 

[Rwfeath92]

Unmarked has typically indicated S30V, but that info is dated. Strider primarily uses particle or powder steels that are tougher than ingot equivalents when properly heat and cryo treated. Performance differences between Strider steels are said to be indistinguishable by end users. In personal experience, I've used Strider's S30V more than any other, and it has become what I consider my benchmark for S30V. Just thinking, this would be a good alternative to a Kiridashi.

What's the thickness?

I don’t have a tape on me right now but I’d guesstimate around 3/8”. I can confirm after work

 

[Rwfeath92]

Unmarked has typically indicated S30V, but that info is dated. Strider primarily uses particle or powder steels that are tougher than ingot equivalents when properly heat and cryo treated. Performance differences between Strider steels are said to be indistinguishable by end users. In personal experience, I've used Strider's S30V more than any other, and it has become what I consider my benchmark for S30V. Just thinking, this would be a good alternative to a Kiridashi.

What's the thickness?

Man was I off with 3/8” lol. It’s about 1/4” thick

 

[Rwfeath92]

Sold