I am in Ontario Canada, Price includes tracked insured shipping to USA I accept Paypal.
Spyderco Farid K2 in CPM 10V. This is a large folder in a barebones design, but it makes an awesome slicer/utility knife. This is a duplicate that I have carried a couple times, smudges in photos are fingerprints on the blade. There is one light rub on the clip, and the stonewash finish on the Ti scales/frame, hides snail trails.This knife will hold an edge for a long long time. The knife was bought new in Canada. And the box, papers etc, are all there. I would call this like new apart from the clip scratch which I have shown in the close up but is very hard to see, except in certain light.
This knife, was basically a backup while my other one was off getting a regrind
I don't need it now. This model tested better than any other production model in Ankerson's edge retention testing, 
The CPM 10V is run HARD, (tested at over Rc64.5, Ankersons was Rc 63). And even at this hardness I have had the edge on my regrind (Rc 65 tested) roll very slightly (tiny shiny spot) when cutting on a plate (loaned it to someone) instead of chip, even at 15dps... This steel is pretty amazing.
Cleaning out remaining duplicate knives !!!SOLD!!!! Asking $190 USD or trade for BM 940-1 or ZT0770CFM4 IF you think this is out of line, make me an offer.
20160105_120723 by rapt_up, on Flickr
20160105_120652 by rapt_up, on Flickr
20160105_120621 by rapt_up, on Flickr
20160105_120419 by rapt_up, on Flickr
Spyderco Farid K2 in CPM 10V. This is a large folder in a barebones design, but it makes an awesome slicer/utility knife. This is a duplicate that I have carried a couple times, smudges in photos are fingerprints on the blade. There is one light rub on the clip, and the stonewash finish on the Ti scales/frame, hides snail trails.This knife will hold an edge for a long long time. The knife was bought new in Canada. And the box, papers etc, are all there. I would call this like new apart from the clip scratch which I have shown in the close up but is very hard to see, except in certain light.
This knife, was basically a backup while my other one was off getting a regrind
I don't need it now. This model tested better than any other production model in Ankerson's edge retention testing, The CPM 10V is run HARD, (tested at over Rc64.5, Ankersons was Rc 63). And even at this hardness I have had the edge on my regrind (Rc 65 tested) roll very slightly (tiny shiny spot) when cutting on a plate (loaned it to someone) instead of chip, even at 15dps... This steel is pretty amazing. Cleaning out remaining duplicate knives !!!SOLD!!!! Asking $190 USD or trade for BM 940-1 or ZT0770CFM4 IF you think this is out of line, make me an offer.
20160105_120723 by rapt_up, on Flickr20160105_120652 by rapt_up, on Flickr20160105_120621 by rapt_up, on Flickr20160105_120419 by rapt_up, on Flickr
Last edited: