- Joined
- Aug 31, 2011
- Messages
- 3,078
Steel: AEB-L
Heat Treat: Paul Bos, 61 RC
Blade Length: 4 3/16"
Overall Length: 8 1/2"
Spine Thickness: .135"
Handle: chunky G-10 liners, Dymaulx, copper pins and tube, G-Flex epoxy. The pictures at the top don't show the modifications; the pictures at the bottom do.
Sheath: 7-8 oz cowhide, copper rivets, synthetic thread, Sno-Seal
Thickest Part Of The Handle: .85"
This knife has some cosmetic blemishes, which are visible in the pictures, and I Have added captions to describe those blemishes.
Plunge lines look a little rough:
On the left side, the bevel is wonky near the plunge line. Also if you look closely you may see scratches near the spine about an inch from the tip:
There is some discoloration on the bottom of the finger guard area:
I am asking $85, which includes Priority Shipping anywhere in the USA.
Thank you for looking and feel free to ask any questions.
Heat Treat: Paul Bos, 61 RC
Blade Length: 4 3/16"
Overall Length: 8 1/2"
Spine Thickness: .135"
Handle: chunky G-10 liners, Dymaulx, copper pins and tube, G-Flex epoxy. The pictures at the top don't show the modifications; the pictures at the bottom do.
Sheath: 7-8 oz cowhide, copper rivets, synthetic thread, Sno-Seal
Thickest Part Of The Handle: .85"
This knife has some cosmetic blemishes, which are visible in the pictures, and I Have added captions to describe those blemishes.
Plunge lines look a little rough:
On the left side, the bevel is wonky near the plunge line. Also if you look closely you may see scratches near the spine about an inch from the tip:
There is some discoloration on the bottom of the finger guard area:
I am asking $85, which includes Priority Shipping anywhere in the USA.
Thank you for looking and feel free to ask any questions.
......Like the leather work you're doing to....