SPF! Drop Point Hunter, CPM154, Stainless Bolster, Budgeroo Burl

Status
Not open for further replies.
M.McAlevy

M.McAlevy

Knifemaker / Craftsman / Service Provider
Feedback: +47 / =0 / -0
Joined
Feb 16, 2014
Messages
907
Hello Blade Forums, I hope everyone is enjoying the weekend. Today I have a new Drop Point Hunter for sale. Spec's are below. Bolsters fit up is good and peened pins are not visible. The blade was ground thin and is razor sharp. This knife is very light and comfortable in the hand. The balance point is right at the index finger grip due to the tapered tang. The wood is from the Timber Joint. They sell the nicest Budgeroo and Ringed Gidgee I have seen. I have not yet added my makers mark. It will be put on the spine.

I welcome any questions or comments. Thanks for looking.

9" overall length, 4" blade length
CPM154 hardened to 59RC (tested), cork belt satin finish
416 Stainless bolsters, pinned
Budgeroo Burl handle with brass pins







$150 shipped USA only
A custom fitted leather sheath can be added for $25. You can look at my website for examples of
sheaths I have made. Sheath will take a few days to make.
 
Last edited:
Sakohunter264 said:
Does the knife have your makers mark? Beautiful stuff!
Click to expand...

Thanks for reminding me. I just updated my post. My makers mark is not on the knife but will be added to the spine prior to shipment. :thumbup:

Thanks for the compliment as well.
 
I would like this but I don't get paid till Thursday would that be acceptable? From mike if it's good with you I will happily take it and thanks so very much
 
Last edited:
Caribou guide said:
I would like this but I don't get paid till Thursday would that be acceptable? From mike if it's good with you I will happily take it and thanks so very much
Click to expand...

Hi Mike, Thursday would be fine. I will mark this SPF. Thanks.
 
Status
Not open for further replies.
Back
Top