Spyderco clip screws..

[Kimber Pro Tac]

Feel free to move this if it's in the wrong area, wasn't sure where to post. I need some of the little screws to hold the clip on Spyderco Endura, Delica, etc. Does anyone here on the forum have them, or best to get from Spyderco, or ??? I need three now, as clip is off knife, but would like 12 or more, as I'm sure I'll lose more. Thanks friends.. lockedandloaded (at) Comcast (dot) net

 

[12345678910]

You can buy them from several sources, the most difficult part is knowing what size they are.


I'd bet they are some metric size.

Unless you have an original to measure, and the tools to measure them with, it's easiest to go direct to Spyderco




http://www.microfasteners.com/catalog/products/MSCMSPP.cfm
is a good resource

 

[Kimber Pro Tac]

That's a great source, thanks. Would anyone happen to know the size? I do not have the tools to measure them. Thank you Numbers!

 

[WA Martin]

I've dealt with Spyderco before. If you tell them the knife you need them for they will likely give you a small helping of them. They might even sell you some if you ask. Just tell them the knives they go to.

 

[Kimber Pro Tac]

I've dealt with Spyderco before. If you tell them the knife you need them for they will likely give you a small helping of them. They might even sell you some if you ask. Just tell them the knives they go to.

Thank you Sir, I will do that. Much appreciated!