Spyderco Pacific Salt Wave Mod

cool man, yeah I'd like to see photos of that for sure.

Here is mine (I am pretty sure you have seen these though). I posted these up a few months back...

img9783hc.jpg

img9323i.jpg


Here is an early photo from the work in progress...


I made some videos about this knife too if anyone is interested...
http://www.youtube.com/watch?v=nS-tGOUyXE8
 
Last edited:
Holy explative. This is exactly what i wanted to do to mine. Once again, though the thread comes back from the dead, thank you Blade forums for bringing mad scientists together. I will be using this mod for my jungle trekkerr H1 spyderco.
 
Holy explative. This is exactly what i wanted to do to mine. Once again, though the thread comes back from the dead, thank you Blade forums for bringing mad scientists together. I will be using this mod for my jungle trekkerr H1 spyderco.

I am curious to anyone having done this wave mod to their knife. Did you have issues with screwing the temper of the blade, or just be careful to quench it often while removing stock?

Thanks in advance
 
I dipped it every 30 seconds or so. It was a very slow process, but at least I knew that the blade stayed cool. I also tried to not use much pressure while using the dremel, because that would greatly accelerate heating.
Slow and steady...
Here's my military

Otk7hj9.jpg
 
Back
Top