BrickForBrains
Gold Member
- Joined
- Mar 3, 2019
- Messages
- 130
First "I'll Take In" in the thread (chronologically) holds priority.
Spyderco S110V PM2 REK Custom - Price Reduced Again - Sold - PayPal G&S - CONUS
The knife is lightly used, centering favors the lock side slightly, the blade drops open and shut freely.
Josh at Razor Edge Knives did an incredible job extending the plunge line to maximize the available cutting edge (220 grit finish). The hardware (screws), lanyard hole, and spacer are Bronze anodized Titanium from xxxadrenalinxxx (Australia). A titanium blade stop is included but not installed and the deep carry clip is from MXG Gear (also Bronze Anodized Titanium).
Original box, hardware, and pocket clip are included with purchase. The edges of the G10 show some slight scuffing and the factory stainless lanyard tube was scratched (significantly) during removal, but the knife is otherwise nearly perfect.
I've invested about $480 into this build, but just haven't found to time to put the knife into my rotation, hoping to free up some cash for a fixed blade.
The first photo was taken at REK and predates the titanium hardware.
Spyderco S110V PM2 REK Custom - Price Reduced Again - Sold - PayPal G&S - CONUS
The knife is lightly used, centering favors the lock side slightly, the blade drops open and shut freely.
Josh at Razor Edge Knives did an incredible job extending the plunge line to maximize the available cutting edge (220 grit finish). The hardware (screws), lanyard hole, and spacer are Bronze anodized Titanium from xxxadrenalinxxx (Australia). A titanium blade stop is included but not installed and the deep carry clip is from MXG Gear (also Bronze Anodized Titanium).
Original box, hardware, and pocket clip are included with purchase. The edges of the G10 show some slight scuffing and the factory stainless lanyard tube was scratched (significantly) during removal, but the knife is otherwise nearly perfect.
I've invested about $480 into this build, but just haven't found to time to put the knife into my rotation, hoping to free up some cash for a fixed blade.
The first photo was taken at REK and predates the titanium hardware.
Last edited: