- Joined
- Jun 21, 2013
- Messages
- 130
Today I will be selling my Karambit. Its made from n690 steel and heat treated to 59-60 HRC I might not have a huge curve like most karambit but I wanted to put my spin on it. It also doesn't have a super pointy tip so it wont break as easily. Made it a little rounded like a drop point. The sheath is made from OD Green kydex and has the best fit I have ever made. The rivet holes are made for large tek loc's. I polished the handles because I really like the look and feel of it, Looks like Carbon fiber a little. I made the grind a mirror polish and used a scotch brite belt to give it nice clean grind lines. The spin is left at a mirror polish for contrast and looks. Also the grind is a slight convex grind, ground to a zero grind with a small bevel. Any more info just email me at srgknives@gmail.com I can have this out in the mail tomorrow.
I'm selling this for $160 Shipped
Knife stats
OAL: 12"
Handle length 6"
Blade Length 6"
Blade Thickness .135
Handle material: Polished Black G10 with OD Green liners
Finger hole size little under an inch
I'm selling this for $160 Shipped
Knife stats
OAL: 12"
Handle length 6"
Blade Length 6"
Blade Thickness .135
Handle material: Polished Black G10 with OD Green liners
Finger hole size little under an inch
