- Joined
- Dec 31, 2009
- Messages
- 2,630
Hello Folks, I have one more fresh from the shop. I enjoy building with this type of construction for the contrasting colors. This knife is built very solid with the tang running all the way into the butt of the knife. I use a threaded insert with an 8/32 screw and plug the end with a piece of turned Blackwood. I use an epoxy that will not melt in case I get the brass accents a little too hot while sculpting the handle. I really like this color scheme. I think its pretty cool. I hope you think so too.
Blade is CPM154CM .141 thick and 3.6 from tip to guard. O/A is 7.9 in. Heat treated with cryo and double tempered to 60-61 RC. Worked to a polish and hand satin finished to 2000 grit.
Guard is 416 carefully soldered.
Handle is Jet Black African Blackwood with stabilized Buckeye and mammoth ivory spacers. This handle design with palm swell fits the hand so nicely and is hard to put down.
Sheath is 8-9 ounce hand tooled and hand stitched leather with keeper strap. Knife is help perfectly snug.
Asking (SOLD) shipped conus to your door. My paypal is warrencustomknives@yahoo.com. Thank you all for looking. Alan
Blade is CPM154CM .141 thick and 3.6 from tip to guard. O/A is 7.9 in. Heat treated with cryo and double tempered to 60-61 RC. Worked to a polish and hand satin finished to 2000 grit.
Guard is 416 carefully soldered.
Handle is Jet Black African Blackwood with stabilized Buckeye and mammoth ivory spacers. This handle design with palm swell fits the hand so nicely and is hard to put down.
Sheath is 8-9 ounce hand tooled and hand stitched leather with keeper strap. Knife is help perfectly snug.
Asking (SOLD) shipped conus to your door. My paypal is warrencustomknives@yahoo.com. Thank you all for looking. Alan
Last edited:
