Steel Pitting

If you don't cuss at steel anymore, I don't know if you can HANDLE this stuff! :p :D (joke)

PM me your snail addy, Dan. I don't need any compensation for the postage. I have enough it would be my pleasure to share a bit with you. Consider it "good things happen to those who show kindness" for the efforts you went to for the community here with the 5160. I think it's 3/16 x 1.25"

It's supposed to cool a bit later this week, so I'll be able to get out. I'll USPS Priority it if they deliver to Maine. ;)

Don't bother to thank me now, because later you will regret lying when you find out what this stuff's like to finish. I know I'm older and gone downhill, but I still don't think it's just me. :D
 
Mike,
Try the new CPM 154CM. Talk about a nice finish.
Also, the regular 154CM that I've used is nothing like the old stuff. I remember those days well. Talk about pits and voids. Glad they fixed it.
 
Thanks for the recommendation, Kit. I might just get me a piece soon, especially if it comes in thin stock (3/32 when finished).

I'm riding a wave of prednisone-induced "wellbeing" that might last a month or a little more, and I'd love to get a knife or two made if I can. :D This first week will be used up clearing trash out sufficiently to see if the machines are still there! :rolleyes:

Does this follow 154CM HT recipe? I'd think there may be some slight differences???
 
PM sent Mike and TX again

I would think the HT on the cpm154 would be just about the same..
as the 154CM
it's made of 154 power right?? :confused:
 
You must log in or register to reply here.
Back
Top