steel source?

[peter r]

i need to find 01 precision ground in 1/4 x 3 x 12 inch pieces. ive looked everywhere and can only fin it in 36 inch lengths or higher. if anyone has any of these pieces in offcuts or what ever Please let me know.

 

[go mike]

Here's an 18" length piece: http://www.fastenal.com/web/products/detail.ex?sku=0988106&ucst=t

 

[peter r]

wow thanks.

 

[jll346]

Place your order through the link I provided. It is from Flatground.com. You will not get better quality and bar none the best prices anywhere! https://www.flatground.com/catalog/item.jsp?DEPARTMENT_ID=20&THICKNESS=1/4

They are excellent to deal with.

 

[ken erickson]

I have had good luck with these guys. Might save a few bucks.

https://www.flatground.com/catalog/item.jsp?DEPARTMENT_ID=20&THICKNESS=1/4

Ken

PS, I was posting at the same time as jll346, sorry for basically a duplicate post

 

[Jim Adams Customs]

I have had good luck with these guys. Might save a few bucks.

https://www.flatground.com/catalog/item.jsp?DEPARTMENT_ID=20&THICKNESS=1/4

Ken

PS, I was posting at the same time as jll346, sorry for basically a duplicate post

Might want to check your prices. I noticed the prices on D2 were twice as high as you can get it from Jantz supplies.

 

[jll346]

Might want to check your prices. I noticed the prices on D2 were twice as high as you can get it from Jantz supplies.

Wow Jantz definately has some good prices on D2. Not cheaper for O1 from the few sizes I quickly compared. Jantz also charges an extra $10 on 36" peices (per order). Not bad if you are getting several peices I guess.

 

[Danjal]

Might want to check your prices. I noticed the prices on D2 were twice as high as you can get it from Jantz supplies.

Jantz has the best prices I've found on D2 (unless ordering 36" lengths..they tack on $10 for a handling fee per order), Niagra specialty metals being a close second. Admiral seems to be more expensive on the D2, but overall their prices are lower than the others except for one or 2 types I looked at.

 

[White Rabbit]

On a side note here (sorry about the hijack) but does anyone know of a source for 52100 bar stock? Because I only do stock removal and I was hoping I could pick some up for a razor and a chef's knife, but I don't really have the ability to draw out rod stock or ball bearings.