Steelcraft parts support?

Discussion in 'Todd Begg Knives' started by WValtakis, Oct 7, 2017.

  1. WValtakis

    WValtakis Hand Engraving, Anodizing and Embellishment Knifemaker / Craftsman / Service Provider

    May 29, 2004
    I purchased a Steelcraft Kwaiken on the exchange here in April, and the pocketclip screw was a bit buggered up (in the tightening direction which was weird). I also found it had 12 bearings on one side of the blade and 13 on the other?:confused:

    I put in an email from the website, and I've been in contact with Mark who initially said it shouldn't be a problem to get a new screw and a bearing... unfortunately that was 6 months ago and I keep getting told "They're not available yet":(.

    Any help?

    Thanks,
    ~Chip
     
  2. WValtakis

    WValtakis Hand Engraving, Anodizing and Embellishment Knifemaker / Craftsman / Service Provider

    May 29, 2004
    Bump
     
  3. TomR2

    TomR2

    211
    May 17, 2015
    You might try:
    Reate Knives, Inc.
    U.S. Warranty Division
    Phone: (424) 257-0548
    Website: www.reateknives.com
    Instagram: ReateKnivesUSA
     
  4. WValtakis

    WValtakis Hand Engraving, Anodizing and Embellishment Knifemaker / Craftsman / Service Provider

    May 29, 2004
    If they're sold by Begg I would hope Begg would support them :(

    ~Chip
     
  5. WValtakis

    WValtakis Hand Engraving, Anodizing and Embellishment Knifemaker / Craftsman / Service Provider

    May 29, 2004

Share This Page