Steingass EDC/Hunter **SOLD**

TK Steingass

TK Steingass

Troglodyte Knifemaker
Knifemaker / Craftsman / Service Provider
Feedback: +108 / =0 / -0
Joined
Oct 16, 2010
Messages
5,746
Gentlemen:

For your consideration is this Loveless inspired EDC/Hunter in stabilized Bastogne Walnut/1095. This knife is sized for every day carry and hunting - this is an original Loveless pattern with a blade shortened 1/4" and the handle 1/2" making it 7 3/4" overall length. The flat ground blade was differentially heat treated with Satanite, hand rubbed to 1200 grit and etched to reveal a vivid hamon. The solder joint is perfectly executed with no pinholes. I had the Bastogne Walnut with broken fiddleback figure stabilized by K&G. Superb fit and finish. I hope you like it! The first "I'll take it, PM, or email gets it. $330 delivered CONUS. PayPal preferred to tsteingass@yahoo.com. Thanks for viewing and all comments appreciated.

V/R,

TK

.175" 1095 stock
HT to Rc 60-61
7 3/4" OAL
3 1/2" Flat ground blade
Stabilized Bastogne Walnut
Tapered tang with red liners
Thumb serrations on spine
Rounded ricasso
Pinned/soldered guard
Stainless furniture
Ambidextrous horizontal carry sheath

Hamon-1.jpg Hamon2.jpg
 
That's a perfect size little hunting knife right there now with good steel also. Good job Tim, and on that sheath as well. There's a lot of work in this setup I bet.
 
d762nato said:
That's a perfect size little hunting knife right there now with good steel also. Good job Tim, and on that sheath as well. There's a lot of work in this setup I bet.
Click to expand...
Tx Doug - always a pleasure:)
 
Very nice knife and sheath, also good job on the hamon.
 
You must log in or register to reply here.
Back
Top