- Joined
- Oct 16, 2010
- Messages
- 5,746
Gentlemen:
For your consideration is this semi-skinner in stabilized Tiger Maple/W-1 file. The file was annealed, ground and edge quenched to 66 Rc. The primaries were hollow ground to .025" then steep 20 degree secondaries applied - the knife is hair popping sharp. The primary hollow grinds were belt finished to 400 grit and finally, a super fine scotchbrite belt satin finish - the flats show file serrations. There is an additional set of index finger serrations on the spine. I hope you like it! The first "I'll take it," PM, or email gets it. SOLD delivered CONUS. PayPal preferred to tsteingass@yahoo.com. Thanks for viewing and your comments are welcome.
V/R,
TK
.170" stock - Nicholson File
HT to Rc 66
8" OAL
3 1/2' Hollow ground blade
Stabilized Tiger Maple scales
Black liners on tapered tang
Stainless furniture
Pinned/soldered guard
Index finger/thumb serrations on spine
Satin finish blade
RH vertical sheath
For your consideration is this semi-skinner in stabilized Tiger Maple/W-1 file. The file was annealed, ground and edge quenched to 66 Rc. The primaries were hollow ground to .025" then steep 20 degree secondaries applied - the knife is hair popping sharp. The primary hollow grinds were belt finished to 400 grit and finally, a super fine scotchbrite belt satin finish - the flats show file serrations. There is an additional set of index finger serrations on the spine. I hope you like it! The first "I'll take it," PM, or email gets it. SOLD delivered CONUS. PayPal preferred to tsteingass@yahoo.com. Thanks for viewing and your comments are welcome.
V/R,
TK
.170" stock - Nicholson File
HT to Rc 66
8" OAL
3 1/2' Hollow ground blade
Stabilized Tiger Maple scales
Black liners on tapered tang
Stainless furniture
Pinned/soldered guard
Index finger/thumb serrations on spine
Satin finish blade
RH vertical sheath
Last edited:
