- Joined
- Oct 16, 2010
- Messages
- 5,744
Gentlemen:
For your consideration is this Triple Duty knife in CPM 3V/Black G-10. This new offering was named Triple Duty because by design, it will serve you well as a hunting, utility, or fighting knife. The blade was austenitized at 1950F and triple tempered at 1000F which is the "optimum for maximum toughness and effective stress relief at Rc 59-60" (according to the people that make this tool steel). The blade is double hollow ground and satin finished to 220 grit. The clip is sharpened on this knife but I can dull it to almost sharp at the buyer's request. I'm out of black leather right now so you'll have to wait a bit on the sheath - Wickett & Craig should get me the leather within the week - you may specify right or left hand sheath.
The tang extends 2/3 of the way into the handle and is set in G/flex marine grade epoxy and a 1/16" stainless pin. I hope you like it! The first "I'll take it," PM, or email gets it. $285 delivered CONUS. Paypal preferred to tksteingass@frontier.com. This knife is also listed on my website. Thanks for viewing and your comments are always welcome.
.200" CPM 3V stock
HT to Rc 59-60
9" OAL
4 1/2" Double hollow ground blade
Satin finish
Stainless furniture
Spine thumb serrations
Black/stainless spacers
Black G-10 handle
8-10 oz leather sheath included
For your consideration is this Triple Duty knife in CPM 3V/Black G-10. This new offering was named Triple Duty because by design, it will serve you well as a hunting, utility, or fighting knife. The blade was austenitized at 1950F and triple tempered at 1000F which is the "optimum for maximum toughness and effective stress relief at Rc 59-60" (according to the people that make this tool steel). The blade is double hollow ground and satin finished to 220 grit. The clip is sharpened on this knife but I can dull it to almost sharp at the buyer's request. I'm out of black leather right now so you'll have to wait a bit on the sheath - Wickett & Craig should get me the leather within the week - you may specify right or left hand sheath.
The tang extends 2/3 of the way into the handle and is set in G/flex marine grade epoxy and a 1/16" stainless pin. I hope you like it! The first "I'll take it," PM, or email gets it. $285 delivered CONUS. Paypal preferred to tksteingass@frontier.com. This knife is also listed on my website. Thanks for viewing and your comments are always welcome.
.200" CPM 3V stock
HT to Rc 59-60
9" OAL
4 1/2" Double hollow ground blade
Satin finish
Stainless furniture
Spine thumb serrations
Black/stainless spacers
Black G-10 handle
8-10 oz leather sheath included
Last edited:
It's yours Sir and thank you.
