Super cheap 1055

[JTknives]

I have a line on some 1055 for very cheep like 0.77 a pound. after shipping it might be a buck or so but it would still be very very cheep. i would have order in full bar lengths to get the price. any takers

 

[sunshadow]

what are the dimensions?

-Page

 

[Keith_H]

Is this that strapping?

 

[go mike]

Would 1055 be best for large choppers, or for mixing with higher carbon in damascus?

 

[Sam Salvati]

What are dimensions?!?!

 

[JTknives]

i will call them tomorrow is see what size i can get from them.

 

[JasonSCarter]

Estwing uses 1055 for there tools, hatchets, axes, & hammers. Good Stuff!

 

[NVHammerHead]

Hello:

Depending upon the sizes I could use say a dozen bars...

NVHammerhead
NV

 

[go mike]

Jarod, did you get the sizes?

 

[Troop]

Jarod, did you get the sizes?

Mike, don't rush JT...he's got a "hottie" that he's got to take care of!

 

[JTknives]

I found out that it is raplacment plades for likt the frount of tractor buckets so one side has a taper but if you forge then its not a problem. the thinest thy have is 3/8" x 3" and it goes all the way up to 1" x 8" by 24'. i was thinking the 1" x 8" would be nice because you could slice off chunks from the end and forge into a blade. or you could get the 3/8 3" and split it length wise and you have one that has a forged edge bevel allready .