Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,175
hello all , I recently finished this sweet little knife for every day carry or however you would like to use it . Hope you all like it and I have it priced nice to sell IMHO .
It has a nice high hollow grind from 1/8" A-2 Tool steel and heat treated to a rockwell hardness at 61-62 with the sub-zero ( -110 degrees ) quench . A fine Scotch-bright belt satin finish after a 240 grit belt grind .
O.A.L is 7-1/4" with the blade at 3-1/8 and edge at 3 . It is 1-1/8" wide at the front of handle .
Handled in some Green Canvas Micarta , topped off with black liners and 5/16" Brass Corby Fasteners ( aka bolts ) .
Sheath is right hand carry .
SOLD
$ 145.00 + $8.00 for shipping in the USA . International friends a bit more , write for cost .
pay-pal or postal m/o , check held to clear .
Thanks for looking and hope you like it .

It has a nice high hollow grind from 1/8" A-2 Tool steel and heat treated to a rockwell hardness at 61-62 with the sub-zero ( -110 degrees ) quench . A fine Scotch-bright belt satin finish after a 240 grit belt grind .
O.A.L is 7-1/4" with the blade at 3-1/8 and edge at 3 . It is 1-1/8" wide at the front of handle .
Handled in some Green Canvas Micarta , topped off with black liners and 5/16" Brass Corby Fasteners ( aka bolts ) .
Sheath is right hand carry .
SOLD
$ 145.00 + $8.00 for shipping in the USA . International friends a bit more , write for cost .
pay-pal or postal m/o , check held to clear .
Thanks for looking and hope you like it .







Last edited: