T.A.DAVISON
Slip Joint Knife Maker
- Joined
- Oct 24, 2005
- Messages
- 5,477
NOTE: These are the answers to some questions that folks were a little vague on my knives recently. All this is on my web site.
I do appreciate all the interest in my knives from you guys, thank you!
This knife was made from scratch, I did not use a pattern. I do NOT have any patterns.
It is NOT intergral, I solder the bolsters on to the liners. The shield is double pinned clear threw the liner & shield, it is NOT glued in or just pins welded to the back.
My name is stamped into the blade - by hand, not etched on. I do not use any pivot bushing or washers. Hope this helps some?
I do appreciate all the interest in my knives from you guys, thank you!
This knife was made from scratch, I did not use a pattern. I do NOT have any patterns.
It is NOT intergral, I solder the bolsters on to the liners. The shield is double pinned clear threw the liner & shield, it is NOT glued in or just pins welded to the back.
My name is stamped into the blade - by hand, not etched on. I do not use any pivot bushing or washers. Hope this helps some?


Folder - #704
Scales - Spalted Maple - stabilized & book matched
Steel - 3/32'' ATS34 - Rc. 60 - 61
Bolsters & Liners - Stainless Steel
Shield - Stainless - inlaid & dbl. pinned.
Closed - 3 7/8''
Hollow ground ......... Hand Finished.......... Cryogenic Quenched
Closes dead center .......... Half Stop .......... Razor Sharp.
Very nice walk & talk. ...... Shipped in a protective case.
You can say I'll take it here.
PayPal only please.
Thanks for the looks - any question or comments are welcomed.
Todd Davison
Scales - Spalted Maple - stabilized & book matched
Steel - 3/32'' ATS34 - Rc. 60 - 61
Bolsters & Liners - Stainless Steel
Shield - Stainless - inlaid & dbl. pinned.
Closed - 3 7/8''
Hollow ground ......... Hand Finished.......... Cryogenic Quenched
Closes dead center .......... Half Stop .......... Razor Sharp.
Very nice walk & talk. ...... Shipped in a protective case.
You can say I'll take it here.
PayPal only please.
Thanks for the looks - any question or comments are welcomed.
Todd Davison
~~~$475.00~~~
Sold - Thank You!

.
Last edited: