Tai Goo 4lb long nose cross peen. SOLD

[A C Richards]

Well the 3lb went so I will post the 4lb. This was one of the first runs if not the first run of Tai's hammers. I did modify it a little and put a larger handle on it. The skinny one it was made for just did not fit my hand esp on this big hammer. Since I am not machine free in my shop this hammer sees very little use (like none). It is a great hammer for a machine free shop or for someone who wants to swing some real steel.

Mad by Nathan the Machinist.

Paid $139. Asking $100 delivered in US. Out of US $85 plus shipping.

ETA: As with any steel in the great north wet there is a bit of surface rust I will address before shipping.

 

[bacustomknives]

AC,
How wide is the face of the hammer
Thanks Bill

 

[A C Richards]

It is 1.8" peen is 2.125"x.8"

 

[bacustomknives]

ok thanks pm sent

 

[Nathan the Machinist]

Those were some real metal mashers. The steel is 4150 at about HRC 52 if I recall. I no longer have the ability to turn these (my big bore turning center died) so these are pretty rare.

 

[A C Richards]

Thanks Nathan. This is still available.

 

[bacustomknives]

ill take it thanks Chuck :thumbup:

 

[bacustomknives]

Payment sent

 

[A C Richards]

I will get it out on Monday. Thanks