Tapered tang drop point in AEB-L and Micarta *SOLD*

leifjl

leifjl

Feedback: +18 / =0 / -0
Joined
Nov 27, 2011
Messages
789
The edge was left thin on this one (.010") so, along with a full height flat grind, it'll be a slicing machine.

7.5" tip to butt with 3.25" of usable cutting edge.

Double cryo'ed and triple tempered to 60.5 HRC.

low maintenance, non reflective bead blasted finish on the blade with layered natural Micarta, white G10 and black canvas Micarta scales.

185$ shipped and insured. *SOLD*












I haven't made a sheath for this one yet, just let me know right or left and I'll get right on it.

Thanks for looking everybody!

Leif Lambertson
 
Last edited:
Hi Leif - would you mind letting us know what the pin material is, and what the maximum blade thickness at the spine is? Beautiful work, by the way. Thank you. Mike
 
Thanks again guys!!

I always forget something Mike157, pins are natural Micarta and she maxs out at 1/8" on the spine tapered down to .040" if I remember right.
 
Sounds good to me. Can't resist a beautiful, slicey piece of AEB-L. Thank you Leif. I will take it. PM on its way. Mike
 
You must log in or register to reply here.
Back
Top