- Joined
- Sep 9, 2015
- Messages
- 3,564
Hi everyone.
I am selling my custom chopper i made as a test knife.
I wanted to test out the high hardness low temper protocol for 3V. (I use peters for all my HT). 61HRC at 0.275 thick with a slight distal taper. Also i tested out the new epoxy from Combat Abrasives. So far its held up great. This was designed as a test blade so its made to used beat up, and had fun with. The handle has 2 small spots that arent 100% symmetrical, but the rest of the handle is comfortable and symmetrical.
I will clean it up for the buyer and make a kydex sheath for it. I had some unexpected bills come up and need it sold.
Looking for $450. I'll eat shipping costs.
I am selling my custom chopper i made as a test knife.
I wanted to test out the high hardness low temper protocol for 3V. (I use peters for all my HT). 61HRC at 0.275 thick with a slight distal taper. Also i tested out the new epoxy from Combat Abrasives. So far its held up great. This was designed as a test blade so its made to used beat up, and had fun with. The handle has 2 small spots that arent 100% symmetrical, but the rest of the handle is comfortable and symmetrical.
I will clean it up for the buyer and make a kydex sheath for it. I had some unexpected bills come up and need it sold.
Looking for $450. I'll eat shipping costs.
