The "JWC PHOENIX FIGHTER " Sold

Jack O'Neill

Gold Member
Feedback: +177 / =0 / -0
Joined
Nov 15, 2007
Messages
7,175
Hello all , Thanks to the courage and kindness of one of our own great makers here on the forum letting me borrow the profile of one of his outstanding works and adding a few of my own touches , I am able to offer you this fighter .

This is double hollow ground from .142 V4E powdered metal , heat treated to an HRC 63 , using the recipe from Larrin Thomas book . The top swedge is not sharpened but can be upon request .
The Overall length is 10-1/2" ,
Blade to the plunge line is at 5-1/4" , it is 1-1/2 edge to spine

Handled in Stabilized African Wenge with white liners , 2 - 5/16 S.S. Corby bolts and a center mosaic pin .
Sheath is 8 oz. veg tanned leather , golden brown dyes .

$265.00 shipped in the USA , international friends write for actual shipping cost . Pay-pal , postal m/o or check held to clear .
My PP is sandlot@charter.net , which is my e-mail also .
Thanks as always for viewing my offerings and comments welcome .

IMG_7960-2.JPGIMG_7961-2.JPGView attachment 2165944
 
Last edited:
Great looking knife! Good materials choice too. :)
 
Are you going to make more of these? It is super cool
Not right away , that was a one up special for that steel . the owner may end up with the only one , just as your little guy was ,keep it clean .
Jack
 
Last edited:
Back
Top