Thoughts on custom scales for 940 specs?

[sharp_edge]

yes, all of my current knives have a flipper. I actually made a thread about what should my new EDC be. I was hoping for a sleek design with a pronounced flipper. Any suggestions by any chance?

Folks already suggested but you are just not listening On the large side you have ZT 0452cf or g10; on the small side you have ZT 0450cf or ti.

 

[Gideons]

Folks already suggested but you are just not listening On the large side you have ZT 0452cf or g10; on the small side you have ZT 0450cf or ti.

I am listening, but neither quite fit my requirements. The ZT 0452CF is too large, and the ZT 0450CF is too small I believe, I may buy it but I doubt the handle will be large enough.

 

[sharp_edge]

I am listening, but neither quite fit my requirements. The ZT 0452CF is too large, and the ZT 0450CF is too small I believe, I may buy it but I doubt the handle will be large enough.

How about Reate Wave (on sale now for $300) or Reate Liong Mah Warrior?

 

[evilgreg]

yes, all of my current knives have a flipper. I actually made a thread about what should my new EDC be. I was hoping for a sleek design with a pronounced flipper. Any suggestions by any chance?

If you want something that's a similar size to the 940, but think the ZT 0450 is too small-handled, what about the ZT I've actually carried the most out of all the ones I own, the ZT 0770cf? It's wider, sure, but similarly sized and actually a bit thinner, and it carries very well. I carry it a lot, despite my general loathing for assisted knives, because unlike most ZTs it's a great slicer and for a thin, light knife it also has a very comfortable handle.