Ti Cyclone Mods

Thanks SPXtrader, but I was hoping for a little more detail. Like approximately how long will the Ti slabs will need to be heated, before they'll start to turn blue?


I'm guessing the choil could be cut using a barrel stone on a dremel...but I'm a bit nervous to try it:eek: A choil would make this knife perfect:D:

Davereb
 
I have a 2 x 72 belt grinder and fit a 3/4" dia roller on it.

If you don't have a belt grinder, you can get cheep arbors that fit on a drill with abrasive sleeves to fit the rubber arbor.

Or a Drimel tool: they have the same thing (only a smaller dia.)

With the flaming, you just have to be bold, try it. Rember, you can blast or sand your mistakes out and go again.:thumbup:
 
You must log in or register to reply here.
Back
Top