DanGraves
Knifemaker / Craftsman / Service Provider
- Joined
- Mar 5, 2006
- Messages
- 2,654
I just completed this one and have not posted one for sale here in a while. Hope you like it. Nickel silver pin in stabilized (by KMG) burl redwood. I made the Damascus out of 1084 and 15n20 steel. Was 1st etched in ferric chloride and then the Coffee etch. If you don't know about it here is a link that explains it. Whats great about it is the black oxides don't easily wipe off.
http://www.brokebladesmith.com/blog/2017/12/23/coffee-treating-damascus-blades
Blade has a good distal taper that starts a the plunge grind. It was flat ground to 0.0065 at the edge before second bevel. the thickest part of the blade is about 0.151 It is razor sharp.
The blade has a 3D effect in light that the camera just can't pic up.
SOLD SOLD
Cutting edge length is 6 1/8 inches and overall length is 10 7/8 inches.
"SOLD" and 8.00 for mail in USA . My paypal is dangraves4923@earthlink.net Thanks and enjoy the photo's I also take check or money order. 1st I will take it.
Don,t say Damascus when paying by paypal as homeland security will put a hold on it.




http://www.brokebladesmith.com/blog/2017/12/23/coffee-treating-damascus-blades
Blade has a good distal taper that starts a the plunge grind. It was flat ground to 0.0065 at the edge before second bevel. the thickest part of the blade is about 0.151 It is razor sharp.
The blade has a 3D effect in light that the camera just can't pic up.
SOLD SOLD
Cutting edge length is 6 1/8 inches and overall length is 10 7/8 inches.
"SOLD" and 8.00 for mail in USA . My paypal is dangraves4923@earthlink.net Thanks and enjoy the photo's I also take check or money order. 1st I will take it.
Don,t say Damascus when paying by paypal as homeland security will put a hold on it.




Last edited: