Titanium blocks 4 3/4" x 5" x 1/2" and Sheets 4" x 6" x .063"

[Atlas Knife Company]

Overflow of my last purchase of Titanium for folders. Each piece measures roughly 4" × 6" × .063". Depending on your design, you can get 3-4 liners out of each piece. It is 6Al4V and I've anodized a corner of each piece just to prove it's Titanium. I'm asking $5 shipped for each piece.
I have three left that are warped. If you have a forge and a press, they will flatten nicely. $10 for all three.


I still have some thicker chunks if you want some. $13 each shipped. They measure 4 3/4" × 5" × ½". You can get quite a few guard from each piece.

 

[Jim Coffee]

i will take 4 pieces of the .063, can you send me your pp info? thanks jim

 

[Chuck Gedraitis Knives]

I will take 4 pieces of the .063, can you send me your pp info?
Thanks,
Chuck

 

[Atlas Knife Company]

Sorry, I keep forgetting to put the PP info in there.

paypalsucks@dsmrepair.com

Valid, verified paypal account, not a real e-mail address. Make sure to send your shipping info in the notes of paypal.

8 pieces spoken for, only 4 left.

 

[Seals]

Ill take the remaining 4.

 

[Atlas Knife Company]

Done. That was quick and easy. Reminds me of a Staples commercial, except the computer techs here aren't morons.

 

[Jim Coffee]

paypal sent for 4 pieces..

thanks
jim

 

[Atlas Knife Company]

All three packages shipped out. Expect them in a couple days.

 

[Jsteele]

Damn... i missed out.

 

[Atlas Knife Company]

I've got three pieces left. Apparently I can't count, there were 15 in the photo, not 12! The three remaining pieces are a little warped. If you have a press you could easily flatten them out if you heat them to orange.

They're yours if you want them, JSteele.

 

[Jsteele]

I don't have a press.. so they would be a problem for me.

 

[S.H.O.P]

any of the thicker 1/2in stuff left?

 

[Atlas Knife Company]

All 4 pieces are left.

 

[J. Rosa]

If there are any of the 4" x 6" x .063" left I will take them.

 

[Atlas Knife Company]

I have three pieces of .063 left, but they are slightly warped. Do you still want them? If so, send the paypal.

 

[J. Rosa]

Ahh. I see. Hence the other poster's comment. I'll have to pass too, sorry. Thanks for the quick reply though.

 

[Atlas Knife Company]

Anyone interested in 12"x10"x.040" sheets? I can get 14 of them for $10 each, shipped. Not sure how I'll ship these, though, they're larger than the flat rate envelopes. I also just got some 6" x 1.75"x.040. I figure 2 pieces for $5 shipped. I've got a great supplier. Dirt cheap and only rarely send me a piece of stainless instead of Ti. Never know what he has or when he'll have it.

 

[Atlas Knife Company]

Closing this thread since these are sold and the others are unusable. And, I cut up one of the 1/2" blocks for my Godzilla.