Titanium Frame lock WIP and introduction

Dalibor

Dalibor

Joined
Apr 7, 2007
Messages
220
Hello everyone ,

i've been a member for a while and read these forums daily but as you can see i don't post much...
learned a lot here so i wanted to share my latest creation :) lots more work but you can see where it's going

specs:

blade: cpm 3v .220" ~ 5.5mm
handle: titanium .150" ~ 4mm
pivot: 420 stainless steal .390" - 10mm diameter (no yet heat treated)
standoffs: titanium (i made these 4 and in the process broke 7 taps :grumpy: )
i got all my material from AKS

now to the pictures:
3-3.jpg

2.jpg

1.jpg



hope you enjoyed these..

regards, dalibor
 
Last edited:
thank you Colton!

dented ball and clip holes are done, just left the blade for HT, today i'll work on FF of the titanium handles and tomorrow or the day after the knife should be complete :)
 
Well can not wait to see it and I can just tell you put a lot of thought into that knife
 
updated the first post with pictures of a finished knife... i used the 'Jake Hoback' finish :)
 
That looks awesome, very nice job! Was this a personal project or something you're selling?
 
i'd love to sell a few so if anyone wants it i'll definitely sell it :) and update my status to 'knifemaker' of course..
 
so handles are almost done...some sanding and FF still to be done,
blades are roughly profiled , tomorrow i'll try to get at least one completely done...


10-2.jpg

9.jpg

7-2.jpg

8-1.jpg

5-2.jpg

4-3.jpg

3-3.jpg

2-2.jpg

1-2.jpg

2.jpg

1.jpg
 
You must log in or register to reply here.
Back
Top