Today I found out that my boss... is a beautiful stripper! I got pics to prove it

View attachment 1170545
resinguy said:
Love the BJ. Your stripper set-up is much like what my own has evolved to. Simple and effective. Full height flat grind blades tend to give very clean surfaces. I'm too lazy to etch the logo, but will finish the 'ghetto satin' by cleaning up with a Scotchbite wheel.

What did you use for the final finish? Very nice.
Click to expand...
Thanks man! I believe the CG BJ is full height convex. At least this one is. The etching part isn’t that bad. I got it down pretty good. It is satisfying to see that Busse Logo deep in the Infi after the coating is gone. I used a Dremel brand set of wheels. Finishing abrasive buffs. These seam like a scotch pad material.
 
Be it full height flat or convex grinds, they do make for the best finish. For example my DS6 with its flat surfaces and fuller was much more difficult. This Boss Jack was pretty darn easy. I just ran those wheels in nice straight lines from spine to edge.
 
You must log in or register to reply here.
Back
Top