Torx Bits Screw Drivers for Folding Knives

I've head that the Benchmade Blue Box bits (BBBB?) are much more likely to strip than quality tools. After stripping a cheapo driver (and the screw I was trying to unscrew), I've only owned Wiha bits/drivers, and have never been disappointed.
 
Keep a WIHA 1/4" bit set at work and have the Husky set as seen above at home.

I got the Benchmade Blue Box set free with a knife and the bits are too soft. I find it telling that they give you six bits, 2 each of 3 different sizes, like they expect you to strip them. I'm not even sure where I keep the blue box anymore.
 
this is a nice thread, because I need to buy some quality torx bits. I think I need T6 T8 and T10.

are there any bit kits with these small sizes?
 
The Wiha set I have uses individual drivers from T3 through T10, I think it cost something like $25.
 
I mostly only need a T6, T8 or both for my folders. Picked up this set of CraftsmanT5-T9 for around 10 bucks. I have my good old Snap-On's in case i need anything larger - you dont want to know how much those cost and i bought them in the late 80's, they were a specialty tool, hardly anyone used torx heads back then from what I remember.
IMAG0076.jpg
 
You must log in or register to reply here.
Back
Top