Torx sets? Brands?

Wiha and Wera are about the same quality ... and by far the best. FWIW, Wiha are made in Germany (Wera is a German brand but they are made in nearby countries. I like the Wera bit holders better than Wiha's.

My absolute favorite is the Wera ESD Kraftform Kompakt.

wera.jpg

BTW, my favorite tool (since we are at it) is the Wera Zyklop (Genius!!).
 
Also at Home Depot, see their 'Husky' set below. I have two of these, and they've worked very well for my needs. I like the pocketability the best; all the bits store in the handle. Sizes T4/T5/T6/T7/T8/T9/T10/T15 in 4 double-ended bits. HD also has an equivalent set in straight/phillips bits.

0cc66c97-59bd-467d-9c41-48fff3c20a49_300.jpg


Lowe's has a similar set in their 'Kobalt' line (I have one of those, too).

820909602729lg.jpg


Both of these brands run about $7 or so. Not bad.


David
 
Last edited:
Do it best hardware here in Texas has a full range of Torx drivers. They are pricy, but hardened ends and well build all around so they last
 
I bought several Sears Craftsman torx drivers over the years. I think I have three sets of T-6 & T-8 drivers. Good quality and I can swap them out if they get damaged. I've had one or two get bent over the years. Hassle free and good quality.
 
I use a set I bought on Amazon for $12 called "Boxer 30 Pcs 4mm Precision Screwdriver Set"

Comes with the smaller sizes of hex, torx, phillips, and flat.

The bits are all magnetic and hardened steel. I've worked them hard on some very small loc-tited hex screws and not even a hint of damage to the bits. The driver is a great size and fits in the hand well. No reason to spend more now that I've found this set.
 
Good to hear feedback on the HDX I've used it twice so far without a problem but if they are on the softer side I'll have to be carefull, it sounds like I'm gonna be buying a Wiha, thanks guys.
 
I was gonna say "Wiha" but two dozen folks beat me to it. Wiha and Mora are the closest we get to unanimity on BF.
 
Back
Top