Tracker's Forge Extra Heavy Skinner For Sale

B

Bob Alderman

Feedback: +1 / =0 / -0
Joined
Mar 24, 2009
Messages
459
Hi,

This is my Extra Heavy Skinner .

done_extraheavyskinner_c_1024.jpg


The knife is 9 inches overall, with a 4 1/4 inch blade.

It has a 1/4 inch 1095 High Carbon Steel Blade w/ Acid Etched Finish.

The Handle features Stabilized Burl Scales over Brass Liners w/ Brass Pins, Extra Heavy Brass Bolsters Dovetailed to the Burl Scales, and Entire Spine is Fully File Worked.

$250 and that includes a sheath. This is a one off, and will not be made again.
 
Last edited:
Looking at your knives posted, you do very nice work. :thumbup:
If I can offer a suggestion, I believe adding more pics to each one would help your cause. Showing handle thickness, file-work, etc. goes a long way when potential buyers are relying on pics to decide if they're going to buy or not. Just sayin'.
 
Your wish is my command....

I had noticed that such shots would probably help. In fact, for this model, I have some....

In closed hand.....

extrahvy_inhand02.jpg



In open hand....

extrahvy_inhand01.jpg



Spine of the knife, towards the tip....

spine_tip.jpg


Spine, towards the rear.....

spine_butt.jpg



Opposite the Spine....

spine_edge.jpg



Thank you,
 
That my friend, is a very nice blade. The file work and the etch really set it off. If I was not 5 knives deep this month already I would pick it up! Very nice work.
 
You must log in or register to reply here.
Back
Top