Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,176
Good morning all , I have this new Hunter to offer up . I hope you like it .
This has a full Flat grind from 3/16th A-2 tool steel and a fine scotch-brite belt finish after a 220 grit belt finish . Heat treat to an Rc. 61-62 with the sub-zero quench .
O.A.L is 9"
Blade - 4-1/2" and 1-1/4 edge to spine at the plunge cut .
Handled in Onyx Composite , red liners and Stainless Mosaic pins .
Sheath is right hand carry 7-8 oz veg tanned leather , saddle tan dyed and mink oiled finished .
$ 235.00 includes fees and shipping in the USA , international shipping a bit more , write for cost .
Pay-pal , postal m/o or check held to clear . . My PP is sandlot@charter.net
Thanks for looking and comments always welcome
This has a full Flat grind from 3/16th A-2 tool steel and a fine scotch-brite belt finish after a 220 grit belt finish . Heat treat to an Rc. 61-62 with the sub-zero quench .
O.A.L is 9"
Blade - 4-1/2" and 1-1/4 edge to spine at the plunge cut .
Handled in Onyx Composite , red liners and Stainless Mosaic pins .
Sheath is right hand carry 7-8 oz veg tanned leather , saddle tan dyed and mink oiled finished .
$ 235.00 includes fees and shipping in the USA , international shipping a bit more , write for cost .
Pay-pal , postal m/o or check held to clear . . My PP is sandlot@charter.net
Thanks for looking and comments always welcome
