ttttttttttttttttttttttttttt

Status
Not open for further replies.
Feedback: +22 / =0 / -0
Joined
Dec 15, 2008
Messages
335
............................................................
 
Last edited:
Sounds like it[s been damaged.

It a used item I bought it used
Spot weld on handle stop
Like I say you should be familiar whit
This type of repair

I use a few times,
Work well.

I don’t need it that much
I tap on my drill press whit tap handle and Gide

$sold
Compare to the price of a new unit
 
Last edited:
This seames to be a great price. if i remember right there was a one kinda like this listed here a while ago that went for a whole lot more then this. I would get it but i Power tap on a mill so its of no use to me.
 
Sorry it took a few hours to respond. i did say that i'll take it! when i said that it was listed at $80.., now i see price is $90??
 
Status
Not open for further replies.
Back
Top