Phillip Patton
Knifemaker / Craftsman / Service Provider
- Joined
- Jul 25, 2005
- Messages
- 5,365
Steel: 1084/15n20, about 150 layers, twist pattern.
Hardness: 61 RC
Blade length: 4-1/8" for the blue one, 4-1/4" for the burgundy one.
Total length: about 8-1/4" for both
Blade thickness: 3/16" for the burgundy one, slightly thinner for the blue one.
Handle material: black resin soaked wrap over stingray
The ferric chloride I used to etch these was a little too aggressive, and it resulted in a little pitting (visible in the pics), so I'm only asking $ shipped per piece.
I can take paypal, check, or MO. Please send paypal to 2000pjp at gmail dot com
If using a check, allow 10 business days for it to clear before shipment. Please make sure knife is still available before sending payment.
Sheaths are not made yet. I can make aluminum, kydex, or leather.
Thanks for looking!
Hardness: 61 RC
Blade length: 4-1/8" for the blue one, 4-1/4" for the burgundy one.
Total length: about 8-1/4" for both
Blade thickness: 3/16" for the burgundy one, slightly thinner for the blue one.
Handle material: black resin soaked wrap over stingray
The ferric chloride I used to etch these was a little too aggressive, and it resulted in a little pitting (visible in the pics), so I'm only asking $ shipped per piece.
I can take paypal, check, or MO. Please send paypal to 2000pjp at gmail dot com
If using a check, allow 10 business days for it to clear before shipment. Please make sure knife is still available before sending payment.
Sheaths are not made yet. I can make aluminum, kydex, or leather.
Thanks for looking!
Last edited: