Hi All,
The Band saw finally went last night so It's time to raise some cash. So I reduced these way down. Both are made from Aldos 3/16ths 1095 and hardened to about a 59-60 on the Rockwell scale. Both come with a Kydex belt sheath and both are hair popping sharp.
The Specifics: In the top picture, the one on top, the redder of the two.
Steel: 3/16ths 1095 to a Rockwell 59-60
Grind: Hollow on a 10 inch wheel
Length: A tad under 5 inches
Cutting edge: 2 7/8 inches
Length from the tip to the front of the scale: 4 inches
Height: 3.25 inches
Handle width: 5/8ths of an inch, snug and comfortable in the hand.
Scales: Bloodwood with 2 3/16ths brass pins
File work: Vine and thorns pattern along the spine.
Price shipped to the lower 48 with a Kydex sheath $65.00
The Specifics: In the top picture, the one on the bottom, the browner of the two.
Steel: 3/16ths 1095 to a Rockwell 59-60
Grind: Hollow on a 10 inch wheel
Length: A tad under 5 inches
Cutting edge: 3 inches
Length from the tip to the front of the scale: 4 inches
Height: 3.25 inches
Handle width: 5/8ths of an inch, snug and comfortable in the hand. A little more rounded than the top one.
Scales: Sapele with 2 3/16ths brass pins
File work: None
Price shipped to the lower 48 with a Kydex sheath $55.00
Comments are always welcome. Thanks for looking, Ken
Tell me what you think! A lot of work goes into these, feedback would be great.
The Band saw finally went last night so It's time to raise some cash. So I reduced these way down. Both are made from Aldos 3/16ths 1095 and hardened to about a 59-60 on the Rockwell scale. Both come with a Kydex belt sheath and both are hair popping sharp.
The Specifics: In the top picture, the one on top, the redder of the two.
Steel: 3/16ths 1095 to a Rockwell 59-60
Grind: Hollow on a 10 inch wheel
Length: A tad under 5 inches
Cutting edge: 2 7/8 inches
Length from the tip to the front of the scale: 4 inches
Height: 3.25 inches
Handle width: 5/8ths of an inch, snug and comfortable in the hand.
Scales: Bloodwood with 2 3/16ths brass pins
File work: Vine and thorns pattern along the spine.
Price shipped to the lower 48 with a Kydex sheath $65.00
The Specifics: In the top picture, the one on the bottom, the browner of the two.
Steel: 3/16ths 1095 to a Rockwell 59-60
Grind: Hollow on a 10 inch wheel
Length: A tad under 5 inches
Cutting edge: 3 inches
Length from the tip to the front of the scale: 4 inches
Height: 3.25 inches
Handle width: 5/8ths of an inch, snug and comfortable in the hand. A little more rounded than the top one.
Scales: Sapele with 2 3/16ths brass pins
File work: None
Price shipped to the lower 48 with a Kydex sheath $55.00
Comments are always welcome. Thanks for looking, Ken
Tell me what you think! A lot of work goes into these, feedback would be great.
