Two-year old knives for clearance sale (I am back)

D

Dmitry.M

Feedback: +43 / =0 / -0
Joined
Jun 13, 2006
Messages
1,008
I am back after almost two years that I was not able to make anything. The knives listed below were made about two years ago and are new, never used or owned knives. They are naturally tarnished and I decided not to clean\refinish them. The blades were oiled and wiped just before the pictures were taken. The prices are low IMO but you always can contact me and discuss a possible discount.

1. Drop point
W1 tool steel blade. 4-1/8" long x 1-1/8" wide. Hardened with the clay to about 60HRC on the edge. Flat bevels. Etched to create patina.
Black\yellow G10 scales with solid stainless steel pins and oversized stainless lanyard tube.
OAL 8-5/8".
Comes with the hand stitched leather sheath.
No makers mark (I can make it if you require).
SOLD
PayPal preferred (dmitryong@gmail.com)
 
Last edited:
2. Gut hook
3-1/2" long, 1" wide O1 tool steel blade. Flat bevels. Satin finish to about 800 grit.
Black\orange G10 scales with tubular stainless steel rivets and over sized stainless steel lanyard tube.
Just shy of 8" OAL
Comes with the hand stitched leather sheath.

I ask $80 for it shipped ConUS via USPS Priority Mail.
PayPal preferred (dmitryong@gmail.com)
RESERVED
 
Last edited:
3. Wide blade \Skinner.
4-1/4" long , 1-1/2" , 1/8" thick blade made of O1 tool steel. Flat bevels all the way to the spine.
Black\Orange G10 scales with solid stainless steel pins.
Comes with the hand stitched leather sheath.
8-3/4" AOL

SOLD
 
Last edited:
4. Big and heavy engraved Bowie.
Blade: CPM-S30V steel. HT by Paul Bos Heat Treating (60HRC). 6" x 1-1/2" x 3/16" thick. Flat bevels, satin finish to 800 grit.
Guard is Nickel-Silver with brass spacer.
I hand engraved it. My mark and the year are engraved on the bottom front side of the guard.
The butt cover left unengraved so you can personalize it.
The handle is made of nice feathered Black Walnut.
I made leather sheath with a little tooling. I made a leather stamp to match the guard engraving.

I ask $750 for it. Shipping Con US is included.
PayPal preferred (dmitryong@gmail.com)
 
I'll take if still available
1. Drop point
W1 tool steel blade. 4-1/8" long x 1-1/8" wide. Hardened with the clay to about 60HRC on the edge. Flat bevels. Etched to create patina.
Black\yellow G10 scales with solid stainless steel pins and oversized stainless lanyard tube.
 
Dmitry , That is a beautiful bowie. When can we look forward to some more "crazy steel" knives. My buddy has been using the last one to split kindling and just can't wear it out.
 
Got the knife .............nice, very nice. Did I mention sharp? That too. Great work all around.
One question about the blade treatment. Does the patina do anything for corrosion protection?
 
Generally yes. It passivates the surface and keeps the oil. But the blade will still rust if left wet in the sheath or contacted an aggressive chemical
 
Last edited:
You must log in or register to reply here.
Back
Top