timos-
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 22, 2012
- Messages
- 2,212
Hello,
I am expanding my ultra-thin "feather" offerings.
This here is a full 2" wide at heel and 8-1/4" blade length.
The blade is convex ground to near zero from .040" thick stock.
The steel came off the quench plates at RC65+ and was tempered down to about RC63-64.
The handle is a solid piece of curly koa w/ a single pin. The epoxy is rated to 250 deg. F
These are 190$ + shipping. Let me know if you have any questions.
I am expanding my ultra-thin "feather" offerings.
This here is a full 2" wide at heel and 8-1/4" blade length.
The blade is convex ground to near zero from .040" thick stock.
The steel came off the quench plates at RC65+ and was tempered down to about RC63-64.
The handle is a solid piece of curly koa w/ a single pin. The epoxy is rated to 250 deg. F
These are 190$ + shipping. Let me know if you have any questions.
