This knife started out as one of my project knives for the WSS forum neck knife challenge. I decided from the beginning to make several designs and sell a batch of smaller EDCs
I really like this one, but my prototype is 7 3/16 inches long, and that's just a bit over the contest rules. Rather than pull the butt in, I'm making another one and putting this one up.
OAL: 7 3/16, with a 3 1/8 inch blade of 1084 steel. Full quench and temper, differential draw down. Blade is finished pretty bright satin leaving some forge marks in. High convex grind.
Handle is wenge with blue spacers and stainless tubing pins. I haven't deeply textured the wenge, but can do so if you really like the effect of that.
Sheath is a deep pouch Ranger model. Double needle harness stitched. as with any upswept point, you need to watch your sheathing angle and you can eventually push that point through any sheath
Asking $140 for this one, Sold Pending Funds
Thanks for looking!
I really like this one, but my prototype is 7 3/16 inches long, and that's just a bit over the contest rules. Rather than pull the butt in, I'm making another one and putting this one up.
OAL: 7 3/16, with a 3 1/8 inch blade of 1084 steel. Full quench and temper, differential draw down. Blade is finished pretty bright satin leaving some forge marks in. High convex grind.
Handle is wenge with blue spacers and stainless tubing pins. I haven't deeply textured the wenge, but can do so if you really like the effect of that.
Sheath is a deep pouch Ranger model. Double needle harness stitched. as with any upswept point, you need to watch your sheathing angle and you can eventually push that point through any sheath
Asking $140 for this one, Sold Pending Funds
Thanks for looking!
Last edited: