1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Vertical Blade Play w/MXG Gear Pivot

Discussion in 'Maintenance, Tinkering & Embellishment' started by JayDee23, May 15, 2018.

  1. JayDee23

    JayDee23

    2
    Feb 11, 2018
    Has anyone else had this problem? I installed the MXG pivot and screw on my ZT0808 and ended up with a very slight vertical blade play. If I pressed in on the lockbar it would tighten up but would return once it flipped open again. I removed the new pivot and reinstalled the original and it fixed the problem. The MXG pin measured 0.180" and the stock pin measured 0.181" and I believe that is where the problem lies. Just curious if anyone else noticed this.
     

Share This Page