1. Click here to enter the drawing for your chance to win an Ontario Knives Spec Plus SP8 Machete Survival Knife & Ka-Bar Dozier Folding Hunter, , Bladeforums.com swag or memberships!

    Be sure to read the rules before entering, then help us decide next week's giveaway by hitting the poll in that thread! Entries close at midnight, Saturday Sept 7!

    Once the entries close, we'll live stream the drawing on Sunday, Sept 8 at 5PM Eastern. Tune in to our YouTube channel TheRealBladeForums for a chance to win bonus prizes!

    Questions? Comments? Post in the discussion thread here

Vertical forge build

Discussion in 'Hammer & Tongs' started by jakeotter, Apr 11, 2016.

  1. jakeotter

    jakeotter

    32
    Aug 29, 2014
    Hi everyone just wanted to get some feedback and advice on my vertical forge build. Also I'm worried I may have screwed up the angle of my burner tube , concerned I might not have proper angle for a nice "swirl" in the chamber. I'll post some pics of that later, but not sure how much effect that will have on the performance as aside from the hot spot. Any feedback is appreciated! Thanks [​IMG][​IMG][​IMG]


    Sent from my iPhone using Tapatalk
     
  2. melsdad

    melsdad

    521
    Apr 3, 2008
    Is there a layer of wool under the cement?
     

Share This Page