VERY!! Cool little EDC in Ivory and Blackwood (sold)

A

Alan Warren Knives

Feedback: +62 / =0 / -0
Joined
Dec 31, 2009
Messages
2,630
Hi All, Here is another little EDC very similar to one I posted a while back. It was ment to be a custom order that fell through and I am offering it at a discount because of a small flaw in the front ivory spacer where you can see some of the JB weld showing through on the bottom side behind the guard. It is still a Great little knife but am offering it up with an additional discount. I have also added a drawing to show its solid construction.

Blade is of 154 CM .127 thick and 3. in. from tip to guard. O/A is 7 in. Sorry for the less than pefect pics but the grinds are better than they look.

Guard is of carbon fiber

Handle is Blackwood with ivory and stainless spacers. Pin is also stainless.

Sheath is custom leather made to fit very securely.

Asking (sold) shipped in US. I accept paypal. Thank you for looking. Alan
 
Last edited:
Bryan J said:
Great work! Did you use the J.B. Weld to marry the spacers to the tang?
Click to expand...

I did Bryan. That piece might have a small inclusion in it because when I cut the slot in it and slid it onto the tang there was very little play in it and when you look at the drawing the tang is not that close to the edge to cause the epoxy to show through. I hope that makes sense.

I use JB Weld to attach each piece one at a time. I use JB weld because it is heat resistant. Alan
 
You must log in or register to reply here.
Back
Top