Visor Viper

[mykulmorris]

This was my brothers idea, thought I'd finally give it a try. It's experimental so comments are welcome(as always). This is a prototype. 8 1/8" long w/ cold blue finish, almost1/4" thick, edges are 3 5/8" and 2"(yes they're both sharp so you're responsible for laws in your area). As you can see it clips onto car vizor. That hole at the end of the 2" edge is where it 'clicks' into the sheath divot. The hole mid-handle is where I was going to make it first but changed my mind because I didn't want the divot to drag all the way down. $75 shipped conus w/ 100% mbg. Thanks for looking!
-Michael

THIS ONE IS NO LONGER AVAILABLE - ORDERS BEING TAKEN

 

[jsmithknives]

I really like that idea, great job!!!

 

[Johnny Warner]

Straight grind lines. Looks good from one side. What does the other side look like, more photos please?

 

[440hard]

I think you have a winner there!

 

[J-siah]

Straight grind lines. Looks good from one side. What does the other side look like, more photos please?

I have never seen this knife but I have seen Michael grind and would venture to say the the lines are perfect.

 

[mykulmorris]

Straight grind lines. Looks good from one side. What does the other side look like, more photos please?

Both sides identical...

 

[empty5853]

Very Cool Michael:thumbup:

Mark T.

 

[S.Knowles]

Very Cool. You've got some great ideas!

Shawn

 

[Bigfattyt]

sweet looking design. Great concept for the visor clicker sheath.