Jack O'Neill
Gold Member
- Joined
- Nov 15, 2007
- Messages
- 7,193
Hello all , I have this sweet little EDC knife to offer for your consideration .
This has been hollow ground from 1/8" A-2 Tool Steel bar stock , heat treated to an Rc. 61-62 with a sub-zero quench and a fine belt satin finished .
O.A.L. is 6-3/4" with the blade at 2-3/4" and 1" wide .
Handled up in G-10 with gray G-10 Liners and Copper Corby Bolts
Sheath pictured is for reference only . Will make a right or left hand carry when purchased .
$135.00 with free shipping in the USA , International folks e-mail for actual ship cost , pay-pal , postal m/o or check held to clear . My PP is sandlot@charter.net
Thanks for looking
This has been hollow ground from 1/8" A-2 Tool Steel bar stock , heat treated to an Rc. 61-62 with a sub-zero quench and a fine belt satin finished .
O.A.L. is 6-3/4" with the blade at 2-3/4" and 1" wide .
Handled up in G-10 with gray G-10 Liners and Copper Corby Bolts
Sheath pictured is for reference only . Will make a right or left hand carry when purchased .
$135.00 with free shipping in the USA , International folks e-mail for actual ship cost , pay-pal , postal m/o or check held to clear . My PP is sandlot@charter.net
Thanks for looking
Last edited:
